How do I replace my lens?Updated 4 months ago
To remove the lens, gently pull the bottom of the frame that sits on the nose away from the lens. The plastic frame has rounded cutouts that match up and go into the notches in the lens (like puzzle pieces). When the frame and lens disconnect, you may hear a pop. Don’t be concerned, you are removing the lens correctly. Once you have disconnected the bottom of the frame from the lens, start disconnecting the sides and top until the lens is totally free from the frame.
Now to insert your fresh lens. First make sure that all protective films are removed, and that your hands are clean.
Simplify
If you have the Simplify goggles, the assembly is much easier because this model has our “1-2-3 SHRED. Replacement System.” For this set-up you can watch our Simplify lens replacement video, or follow the steps below:
Grab either side of the goggle with your pointer fingers bracing the side of the frame - and your thumbs settled on the front of the lens: Push down and forward until you hear a click.
Go to the opposite side with both hands - pointer fingers bracing the side of the frame, and your thumbs settled on the front of the lens. Push down and forward until you hear a click
Lastly, grab the goggles from the front and squeeze until the lens is flush with the frame in all areas.
HEADS UP! Be careful to not touch the inner lens during the replacement procedure, this will ruin the anti-fog treatment. We recommend that you place your SHRED. microfiber bag over the inner lens.
All Other Models
For all other models, you can watch the lens replacement video below or follow these steps:
Hold the lens with one hand and the goggle frame in the other. Align the nose of the lens with the nose of the frame, and insert the lens into the nose channel only. You will notice the notches in the lens will match up with the cutouts in the frame and click into each other (like puzzle pieces). Then slowly work your way around the frame inserting the lens into the channel; first on one of the sides, then the opposite, and lastly the top.
It’s always good to carry your goggle bag or a cloth in your jacket to do a final polish- Don’t be a Jerry and wipe your goggles with your gloves, jacket or any other rough material.
HEADS UP! Be careful to not touch the inner lens during the replacement procedure, this will ruin the anti-fog treatment. We recommend that you place your SHRED. microfiber bag over the inner lens.